The process starts with our site visit where we measure, inspect and discuss with you the history of the roof and your requirements. Using this information we will be given a specification to follow by the manufacturer.

We wash the roof with low-pressure water in order to remove loose dirt and debris. Then we apply a special green roof cleaner. Before it dries we power-wash at higher pressure using a specialized roofing surface cleaner. We often use leaf blowers to move dirty or ponded water to drains.

History and experience prove that most leak failures occur at a seam. So all penetration points, seams, edging, drains and old repairs are flashed in with a heavier grade silicon with a fabric reinforcement designed to handle these larger details.

The specification directs the install team to apply the layers to specific gallons per foot. We measure the mills to assure proper installation.

On completion we must pass a rigorous onsite testing by the manufacturers' inspectors. As approval is achieved we transfer the warranty to you.